andrews-sykes.com
Operating Instructions
& Safety Guide
General Safety
Electrical Safety
0800 211 611
This equipment should only be used by a competent
person who has read and understood these instructions.
Check condition of equipment before use. If unit is
showing any signs of damage contact your supplier
immediately.
Never operate this equipment if you are ill, feeling tired or
under the influence of alcohol or drugs.
Keep all vents and grills clear of obstructions.
Keep children and animals away from electric powered
equipment. Never leave them alone when the unit is in
use.
Make sure equipment is switched off and unplugged after
use.
This unit operates on a
415 volt 5
pin
32amp power supply
The power cable must be a minimum of 6mm2 up to a
maximum length of 40 meters. All cables over 40 meters will
require a larger C.S.A of cable.
A
lways inspect plugs and power cables for damage before
plugging into power supply.
DO NOT USE IF ANY DAMAGE IS FOUND.
I
f an extension lead is used, ensure it is of the
correct standard
a
nd fully uncoiled before use.
Cables must not be laid in wet or damp areas.
Do not move equipment while operating.
Getting started and operation
Position equipment on level ground.
Position away from any
materials that can
be drawn into the air intake grill.
Do not use within any zoned or hazardous
areas.
Do not position
unit inside of any
building or temporary structure
Keep at least 1
meter
of clearance around
the unit and don't restrict the air flow
around the chiller
The HPAC 30 unit can only be controlled
on outlet Air and not inlet Air
Fig 1
5 pin 32amp 415 volt Appliance inlet
plug found on the HPAC 30
HPAC 30
Cooling model Only
Fig 1
F
i
g 1
