Click
www.andrews-sykes.com
or Call Us Free
0800 211 611
Double Cool
Portable Air Conditioning
Operating Instructions
& Safety Guide
Do not lay electrical cables in wet / damp areas.
Do not move equipment whilst operating.
Do not pull equipment by its cable.
Cleaning and Maintenance
The Andrews Sykes range of evaporative air conditioners are designed to give
many years of trouble free operation. It is however important that the simple
regular maintenance described in this section is carried out.
Note: Isolate the unit from the power supply before carrying out any form of
maintenance.
At the end of each week
Clean side and back cooling pads and removed dust particles wit a vacuum
cleaner. Clean the outside body with a damp cloth.
At the end of each month
Place a sterilising tablet or a capful of sterilising liquid into a full reservoir and
operate the pump to circulate the sterilised water through the whole system. Drain
the water tank and clean any build up with a dam cloth. To gain access to the
water tank you will need to remove on or more panels.
At the end of summer season
Before storing the unit, drain the water tank and wipe down with a sterilising agent.
Remove the cooling pads and wash using a gentle spray. Then allow them to
completely dry before replacing.
General Safety
Keep children and animals away from air conditioning units. Never leave them
alone in a room where the units in use.
This equipment should only be used by a competent person who has read
and understood these instructions.
Never operate this equipment if you are ill, feeling tired or under the influence
of alcohol or drugs.
Keep the Air Conditioning vents clear of all obstructions.
Never put anything on top of the unit or block the air outlets.
Make sure equipment is switched off and unplugged after use. Never leave
switched on or unattended.
Located unit as to protect against accidental or malicious damage
Check condition of equipment before use. If unit is showing signs of damage
contact your supplier immediately.
Electrical Safety
Requires a standard earthed power supply 230v. An extension cable (a
minimum of 1.5mm three core earthed lead) may be used.
Extension leads must be fully uncoiled when being used.
Extension leads must be protected from any possibility or interference or
damage.
Andrews Sykes recommends the use of a power supply that is protected by
an RCD ( residual current operated device). This provides extra safety. Always
inspect the power supply cable and plug for damage before use.
Damaged plugs and powers supply cables must only be replaced by and
authorised repair agent.
Andrews evaporative air conditions are fitted with thermal cutouts which stop
the unit if a pump or fan motor overheats. The cut-out automatically resets
once the motor has cooled.
This unit requires a 230 volt electrical supply. It plugs into a standard BS1363
domestic socket.
Always inspect plugs and leads for damage before plugging into the supply -
DO NOT USE IF ANY DAMAGE IS FOUND
Ensure cables are run as not to cause a hazard.
If an extension lead is used, ensure it is of the correct standard , and fully
uncoiled when being used.
