Andrew Node C, User Manual

Page: 23 / 62

4 Installation
Page 23
4. INSTALLATION
4.1. MECHANICAL INSTALLATION
4.1.1. General
Read the health and safety warnings in chapter
1.2 Health and Safety Warnings .
1. Do not install the unit in a way or at a place where the specifications
outlined in the Environmental and Safety Specifications leaflet of the
manufacturer are not met.
2. It is recommended only to use the mounting hardware delivered by the
manufacturer. If different mounting hardware is used, the specifications
for stationary use of the unit must not be exceeded.
)
Note: Exceeding the specified load limits may cause the loss of warranty.
3. The unit is considerably heavy. Make sure that a suitable mounting
surface is used. Ensure there is adequate manpower to handle the
weight of the system.
4. Due to power dissipation, the unit may reach a very high temperature.
Ensure sufficient airflow for ventilation.
Above and below the units a minimum distance of 300 mm to ceiling,
floor, etc. has to be kept. This distance must also be observed between
two units if they are mounted one above the other.
5. When connecting and mounting the cables (RF, mains, ...) ensure no
water can penetrate into the unit through these cables.
If any different or additional mounting material is used, ensure that the mounting
remains as safe as the mounting designed by the manufacturer. Ensure that the
static and dynamic strengths are adequate for the environmental conditions of the
site. The mounting itself must not vibrate, swing or move in any way that might cause
damage to the unit.
)
Note: Node M and Node C are delivered with a pre-mounted front cover.
This cover is of vital importance for the correct forced airflow and
for passive cooling. Thus, do not operate the unit without cover.