6
Button configuration
Using the appliance
1.
Remove all packaging from the appliance.
2.
Ensure that the voltage of the electrical supply matches that of the rating label
on the unit.
3.
Place the appliance on a flat, level surface.
4.
Plug the appliance electrical cord into the electrical power supply.
5.
Make sure the power switch on the back of the heater is switched to the on
position .
6.
Press the power on/off button, the appliance will automatically be set at 21°C
using half power (1200W).
7.
Please refer to the sections below for other functions of the appliance.
Timer
1.
To set the time follow steps 1-4 in “Using the appliance”.
2.
Press “SET” and the display will now show displays 0 hours, increase the time in
hours using the “+” button. Choose between 0-12 hours, the appliance will
automatically turn off after the time has elapsed.
3.
Press “SET” again to select the temperature and “SET” once more to confirm.
Power on To turn the appliance on and off.
SET
Set both the timer and temperature.
HEAT
Used to set the appliance to full or half power. Press once
to heat the appliance on a low setting (1200W) and twice
to heat the appliance on full power (2000W).
SWING
Rotate the tower block.
+
Increase time and temperature when used in conjunction
with “SET”.
-
Decrease time and temperature when used in conjunction
with “SET”.
7
Heat
When the appliance is turned on it will automatically be set at half heat (1200W), this is
shown in the display of the appliance. To increase to full heat press the “HEAT” button
once (2000W).
Swing
During operation press the “SWING” button to oscillate the tower head. This will allow
for an even distribution of heat throughout the room.
Over heating protection
This product is manufactured with a thermal cut off protection device that will
automatically cut off the appliance if it has excessive heat. Once the heater has cut-off
the appliance allow the heater to cool for 30 minutes. Remove any obstructions to the
airflow before restarting the heater.
Tip-over safety device
It is normal for the unit to have a slight rattle this is because
the appliance comes with a
tip over switch. It will cut the power to the heater if the appliance is accidentally
knocked over. Avoid knocking over the appliance, stand back up immediately.
Care and cleaning
Always ensure the appliance has fully cooled down before beginning cleaning.
Remove the power cord from the electrical supply before beginning cleaning.
Avoid contact with the heated surface.
Do not spray the appliance with liquid for any reason.
Do not clean the appliance with harsh abrasive cleaning agents. Use a slightly
dampened cloth to clean the appliance.
Dry thoroughly before storage.
Store the appliance in its original packaging in a dry protected place, this will
protect it from dust.
