Andrew James 4 Day Automatic Pet Feeder, Instruction Manual

Page: 8 / 36

Getting started
1. Carefully turn the pet feeder
upside down. Remove both
battery doors by squeezing the
two tabs and gently pull each
door away.
2. Keep the ON switch set to OFF.
Insert four C size alkaline
batteries into the battery tray.
Use Good quality alkaline
batteries.
3. Close the battery doors, rotate
the feeder right-side up and
switch ON The feeder will cycle
one time until “12:00” is on the
LCD display.
Note: Your pet feeder makes the
food available in this sequence:
Tray 1, Tray 2, Tray 3 then Tray 4.
When only one feed is required
only fill Tray 1. For two feeds Tray
1 and 2. Continue the sequence on
for further feeds.
Setting the current Clock time
1. Press and hold the SET key for
(2 seconds) to enter Clock SET
mode. The hour number will
now begin to blink.
2. Press the MODE key to increase
the hour. Once you have set the
hour, press the SET key to
confirm the hour. The minute
number will now blink.
3. To change the minute number,
press the MODE key to increase
the minute. Once you have set
the minute, press the SET key
to confirm the minute. Both the
hour and minute numbers will
now blink.
4. If needed, Press the MODE key
to change between 12 or 24
hour time.
5. Press the SET key to confirm
your current time setting and
the numbers will stop blinking.
Setting the Feeding Time
1. After setting the clock time,
press the MODE key one time.
(1 1) will show on the display.
This is the feeding-time display
mode.
2. Now press and hold the SET key
for (2 seconds) to enter the
Feeding
time SET mode.
Feeding will start from the first
feeding number & time. The 1
st
digit shows the feeding number
(Food Tray 1).
3. The hour digit will now blink
(2
nd
and 3
rd
digit). Press the
MODE key to increase the