DN:KD-752-SMSY01 V1.0 Operation Guide
16/19
MAINTENANCE
1.
Do not drop this monitor or subject it to strong impact.
2.
Avoid high temperature and solarization. Do not immerse the monitor in water as this
will result in damage to the monitor.
3.
If this monitor is stored near freezing, allow it to acclimate to room temperature before
use.
4.
The monitor requires 6 hours to warm from the minimum storage temperature between
uses until the monitor is ready for its INTENDED USE when the ambient temperature is
20 °C.
5.
The monitor requires 6 hours to cool from the maximum storage temperature between
uses until the the monitor is ready for its INTENDED USE when the ambient temperature
is 20 °C
.
6.
Do not attempt to disassemble this monitor.
7.
If you do not use the monitor for a long time, please remove the batteries.
8.
It is recommended the performance should be checked every 2 years or after repair.
Please contact the service center.
9.
Clean the monitor with a dry, soft cloth or a soft cloth squeezed well after moistened with
water, diluted disinfectant alcohol, or diluted detergent.
10. No component can be maintained by user in the monitor. The circuit diagrams,
component part lists, descriptions, calibration instructions, or other information which will
assist the user
’s appropriately qualified technical personnel to repair those parts of
equipment which are designated repairably can be supplied.
11. The monitor can maintain the safety and performance characteristics for a minimum of
10,000 measurements or three years, and the cuff integrity is maintained after 1,000
open
–close cycles of the closure.
12. It is recommended the cuff should be disinfected 2 times every week if needed (For
example, in hospital or in clinique). Wipe the inner side (the side contacts skin) of the cuff
by a soft cloth squeezed after moistened with Ethyl alcohol (75-90%), then dry the cuff by
airing.
13. Not servicing/maintenance while the monitor is in use
.
EXPLANATION OF SYMBOLS ON UNIT
Symbol for
” THE OPERATION GUIDE MUST BE READ”(The sign background colour:
blue.The sign graphical symbol: white)
Symbol for
“WARNING”
Symbol for
“TYPE BF APPLIED PARTS” (The cuff is type BF applied part)
