Remove spreader and components from carton.
Place hopper on its front panel, insert two 1/4-20 X
1/2” hex head bolts through the leg; flattened end
of handle brace and holes in hopper as shown.
Install hex locknuts but do not tighten. Repeat on opposite
side.
1
Assembly
Slide wheels onto each end of axle with the
longer portion of the wheel facing the hopper.
Secure wheels with 3/16 dia. x 2” cotter pins.
2
Install control tube between the control tube
braces and secure with two 1/4-20 X 1 1/2” hex
bolt and locknuts.
3
Stand spreader upright on wheels. Attach
upper handle assembly to handle brace (make
sure handle is positioned as shown) using four
1/4-20 X 1 1/2” hex bolts, eight curved wash-
ers, and four locknuts. Tighten securely. Install handle
grips onto upper handle. Slide handle lever assembly
between handle brackets and secure with 1/4 diameter
clevis and cotter pin. Make sure lever pivots freely.
4
Slide the ends of the control tube braces over
the studs on the shutoff bar brackets; secure
with cotter pins. Attach opposite end of control
tube to the handle lever using 1/4 diameter cle-
vis and cotter pin. Make sure handle lever operates
freely.
Tighten all Nuts left loose in Step #1.
Install
hopper handle on front of spreader using two 1/4-20 X
1/2” hex bolts and locknuts.
5
To check spreader for completed shutoff, pull
the handle lever back to the “OFF” position.
Turn spreader over to see if the shutoff bar
completely covers the holes in the bottom of the
hopper. If not, stand the spreader upright on wheels
and push the handle lever forward to the “ON” position.
Loosen the bolts in the hopper holding the handle brace.
Push down on the handle brace and the front of the
Hopper. Retighten bolts and check the shutoff.
6
Leg
Handle Brace
Handle Grip
Handle Lever
Assembly
Locknut
Locknut
Drive Wheel
3
/
16
x 2”
Cotter Pin
Cotter
Pin
Control Tube
1
/
4
” D. Clevis
Hopper Handle
Locknut
1
/
4
- 20 x
1
/
2
”
1
/
4
- 20 x 1
1
/
2
“
Hex Bolt
Locknut
1
/
4
- 20 X
1
/
2
”
1
/
4
- 20 X
1
/
2
”
Hex Bolt
Cotter Pin
1
/
4
” - D. Clevis
Curved
Washers
2
