PRODUCT MANUAL
52ST Below Deck Compact Motor
™
10
STEP 4
Fit drain tube
4.1 Remove the plastic plug from the drain port fitting and push the
drain tube [A12] into the fitting until it stops. Lead the drain tube
below deck to a low point in the boat where it can drain to the
bilge, then cut off any excess length. At most there should only
ever be a drop or two of water from condensation that will pass
through the tube.
STEP 5
Install push buttons
The push button [A1] require 50mm clearance depth below the
mounting surface. It is supplied with a short 190mm (7 1/2”) cable
lead; this is connected below deck to a 1000mm (39”) long control
cable [A10] and then to the short cable leads from the motor.
Extension cables are available and may be ordered separately if
necessary.
5.1 Select the desired location. For safety reasons it is recommended
that the push button [A1] is located in close proximity to the
winch, preferably within reach.
5.2 Determine the preferred orientation of the hinged cover (on
vertical surfaces it should open upwards). Then using the drilling
template (or the rubber gasket [A2] as a guide, drill a Ø25mm
(1”) hole.
5.3 Drill a Ø3mm (1/8”) hole in each of the mounting screw locations.
5.4 Fit gasket and push button in place. Secure the push button
unit with the M4x20mm self tapping screws [A8], using a small
amount of sealant at each hole.
5.5 Ensure that the breather channel on the side of the through-deck
tube of the push button is clear and free of dirt or sealant.
Plastic plug
removed from
drain port
Drain port fitting
Breather
channel
Drilling
template
Mounting
screws
Hinged
cover
Push
button
Rubber
gasket
Push button installation
