ALIGNMENT TABS x4
REMOVE 6 CLIPS
SEALING PLUGS
DUCT KIT INSTALLATION
90-2582
90-2583
90-2584
STEP 2
Attach the assembled duct housing to the dehumidifier using screws provided .
Additional holes will need to be made in the cabinet where holes did not
previously exist . To properly seal the unit, use a 5/32" bit to pre-drill
holes and use the screws provided . If you choose to use self drilling
screws, make sure they are no longer than 1" . To secure the
3 screws on the left side of the duct kit (opposite the filter
access door), a bit extension of at least 6" is required .
After securing all screws, insert the sealing plugs provided
into the access holes on the left hand side .
STEP 3
Install the filter access door and secure with
the two thumb screws .
STEP 1
On each housing, bend the four alignment tabs so they are protruding out of the front of
as shown below . These are to be used as alignment features for the 24" collar .
3
