1. Before moving range, slide range onto
shipping base cardboard or hardboard.
2. Place this template on floor in cabinet
opening so that the left edge is against
cabinet and top edge is against rear
wall, molding or cabinet. (See Figure 4)
3. Tape template in place.
4. If countertop is deeper than 25" (63.5
cm), measure and mark a distance of
25" (63.5 cm) in from front of
countertop and align template with
mark. (See Figure 4)
5. If countertop is not flush with cabinet
opening edge, align template with
overhang.
6. If cabinet opening is wider than
specified in Installation Instructions,
adjust template so range will be
centered in cabinet opening.
7. To mount anti-tip bracket to wood floor,
drill two 1/8" (3.2 mm) holes at the
positions marked on the bracket
template. (See Figure 5)
8. Remove template from floor.
9. Tap plastic anchors into holes with a
hammer.
10. Align anti-tip bracket holes with holes in
floor. Fasten anti-tip bracket with
screws provided. (See Figure 6)
11. Move range close to opening. Remove
shipping base, cardboard or hardboard
from under range. Connect power
supply cord as described in Installation
Instructions. Move range into final
position making sure rear leveling leg
slides into anti-tip bracket. (See Figure
7)
12. Continue installing your range following
the installation Instructions.
Figure 4
Figure 5
Figure 6
Figure 7
18
