BASIC SETUP AND OPERATION
1. Charge the batteries 5-6 hrs.
Note: Belt packs operate about four hours of continuous use per
charge.
(Diagram 2)
2. Find the MASTER belt pack as indicated on the top label. The
Master belt pack must be ON for each of the REMOTE belt packs to
function.
(Diagram 1)
3. Plug headset cable into belt pack & adjust boom.
(Diagram 2)
4. Turn on power and set headset volume. Power ON LED is solid green
and flashing green for LOW battery.
(Diagram 1)
5. Set slide switch to Push to Talk or Always On mode.
(Diagram 3)
6. Choose channel A or B for all belt packs. If both channels are used
at the same time, two master belt packs are required (See page 6).
(Diagram 1)
Note: repeat above for each member’s belt pack in use.
4
MIC GAIN CONTROL
CHANNEL SELECTOR
RX/TX LED
(RED)
PTT BUTTON
POWER LED
(GREEN)
ON/OFF/VOLUME CONTROL
D I A G R A M 1
D I A G R A M 3
PUST TO TALK OR
ALWAYS ON SLIDE SWITCH
BELT CLIP
BATTERY COMPARTMENT
PROLINK BELT PACK
Model Shown: BP-9000M
For videos on how to setup & use the ProLink: www.anchoraudio.com
CHARGING PORT
CHARGING LED
(RED)
XLR CONNECTOR
D I A G R A M 2
5
SYSTEM RANGE
The RF signal will travel through many solid objects. However, the more
solid objects between the belt packs, the more the range will be reduced.
When the belt packs are transmitting, the Transmit LED will flash red. If the
signal drops out, the LED will glow solid red on REMOTE belt packs only. If
the belt packs are too far apart, the REMOTE belt packs need to move closer
to the MASTER belt pack.
