Wireless Operation
(PB-35W)
8
Setting up the wireless system
Set the frequency of the receiver.
The wireless receiver is mounted inside the MegaVox and is
available with two different frequency pairs (this allows for
operation of up to 4 units simultaneously). A label on the
control panel indicates which 2 frequencies your system is
equipped with, and the desired frequency is selected via the
frequency switch.
1. Set the frequency of the receiver to either of the two
channels, F1 or F2.
If you experience ongoing interference problems with your
wireless system, the selected frequency may be incompatible
with other RF systems in your area. Try the other channel.
Set the frequency of the transmitter.
During use, make sure the transmitter you are using is set to
the same frequency as the receiver as set above.
HANDHELD: Set the frequency switch inside the
battery compartment to match the channel of the
receiver. Replace the cover—but don’t overtighten!
BODY-PACK: The power/frequency switch on the
transmitter determines the frequency. During use, set
the switch to match the frequency of the receiver.
Operation
CA
use
Anchor
RC-16
only
CHARGER
Flashing =
fully charged
SPKR OUT
LINE IN
MIC
2
(WIRELESS)
MIC 1
LINE OUT
POWER
Flashing =
low battery
PB-35W
OFF
ON
TX ON
169.445
170.245
Mic 1 Input
(1/4" phone jack)
Line Output
(1/4" phone jack)
Mic 2 Input
(1/4" phone jack)
Charging Indicator
Speaker Output
(1/4" phone jack)
Wireless
Frequency Switch
(PB-35W only)
Power / Battery
Indicator
Power Switch
Line Input
(1/4" phone jack)
Charger Input
(use RC-16 only;
RC-16/220 for export)
MegaVox Control Panel
Operating the sound system
1. Set all input level controls to minimum before
turning on the power.
2. Plug a microphone into one of the Mic input jacks,
or connect an audio source to the line input.
3. Turn power ON (red LED next to switch will light).
If the LED flashes or does not light, the battery must be
charged (see page 7).
4. Adjust the level control adjacent to the input used to
desired volume level.
5
Wireless
Reception
Indicator
(PB-35W only)
TX ON
169.445
170.245
Frequency Switch
frequency switch
label indicates frequency pair
F1
(MHz)
F2
(MHz)
PB-35W-1:
169.445
170.245
PB-35W-2:
171.105
171.845
Consult the
supplemental
wireless
manual if you
have model
PB-35WS.
100-58-0/B MGX 2/6/01 9:49 AM Page 9