Safety
ANCA Motion
D-000129 Rev 09
1
1
1
Safety
Warning:
To prevent possible accidents or injury, ensure you read and understand this manual before
commencing installation or commissioning work on the AMD5x PIU and Servo Drives.
DANGER HIGH VOLTAGE
- The working DC Bus is live at
all
times when mains power is on, even if the bus is
discharged. The Main Isolator feeding the drive must be switched to the
off
position at least 15 minutes before
any work is commenced on the unit. The operator must check the DC Bus voltage with a tested working voltage
measuring instrument prior to removing any covers
Rotating permanent magnet motors can produce large voltages. Please ensure that the motors have stopped
rotating before commencing work.
This manual and the warnings attached to the AMD5x only highlight hazards that can be predicted by ANCA
Motion. Be aware they do not cover all possible hazards.
ANCA Motion shall not be responsible for any accidents caused by the misuse or abuse of the device by the
operator.
Safe operation of these devices is your own responsibility. By taking note of the safety precautions, tips and
warnings in this manual you can help to ensure your own safety and the safety of those around you.
The AMD5x is equipped with safety features to protect the operator and equipment. Never operate the equipment
if you are in doubt about how these safety features work.
The AMD5x system is an Open Type product; the associated module enclosures are rated to IP20 and are
classified as NEMA/UL Open Type. The AMD5x modules must be mounted within an enclosure which provides
access protection, with access only possible with a use of a tool or after de-energization of the live parts.
1.1
General Safety
The following points must be understood and adhered to at all times:
Equipment operators must read the User Manual carefully and make sure of the correct
procedure before operating the AMD5x.
Memorize the locations of the power and drive isolator switches so that you can activate them
immediately at any time if required.
If two or more persons are working together, establish signals so that they can communicate to
confirm safety before proceeding to another step.
Always make sure there are no obstacles or people near the devices during installation and or
operation. Be aware of your environment and what is around you.
Take precautions to ensure that your clothing, hair or personal effects (such as jewellery) cannot
become entangled in the equipment.
Do not remove the covers to access the inside of the AMD5x unless instructed by the
procedures described in this manual.
Do not turn on any of the equipment without all safety features in place and known to be
functioning correctly.
Never touch any exposed wiring, connections, or fittings while the equipment is in operation.
Visually check all switches on the operator panel before operating them.
Do not apply any mechanical force to the AMD5x, which may cause malfunction or failure.
Before removing equipment covers, be sure to turn OFF the power supply at the isolator (refer to
Do not operate AMD5x equipment with the covers removed.
Keep the vicinity of the AMD5x clean and tidy.
Summary of Contents for AMD5x Series
Page 12: ......
