Board Version
Board Version
Revision 1.0 of ANAVI Infrared pHAT was used while writing this document. It is possible that it is outdated so it is always recommended to check the latest sources
from the GitHub page of the board.
CHAPTER 2: Getting Started
CHAPTER 2: Getting Started
Electrostatic Warning
Electrostatic Warning
ANAVI Infrared pHAT is shipped in a protective antistatic bag. The HAT as well as the Raspberry Pi must NOT
NOT be exposed to high electrostatic potentials. A grounding
strap or similar protective device should be worn when handling the board. Avoid touching the component pins or any other metallic element.
Requirements
Requirements
In order to setup ANAVI Infrared pHAT the following items are required:
Compatible Raspberry Pi
microSD card with compatible image
USB power supply
Additionally you may attach USB mouse, keyboard, HDMI monitor or addition peripheral devices to your Raspberry Pi. It is recommended to use 2.5A (2500mA) power
supply.
Supported Peripherals
Supported Peripherals
ANAVI Infrared pHAT Raspberry Pi HAT has an infrared receiver and an infrared transmitter. Up to 3 I2C sensors can be also easily attached to the pHAT.
Sensors
Sensors
The officially supported I2C sensor modules by ANAVI Infrared pHAT are:
Temperature and barometric pressure (BMP180)
Temperature and humidity (HTU21)
Light (BH1750)
You may also attach any other I2C sensors but you will have to take care of their software integration.
Temperature Sensor
Temperature Sensor
The official temperature sensor for ANAVI Infrared pHAT is BMP180. This is I2C sensor capable of measuring both temperature and barometric pressure.
Using 4 Dupont jumper wires connect BMP180 to one of the 3 I2C slots on ANAVI Infrared pHAT as follows:
BMP180
BMP180
ANAVI Infrared
ANAVI Infrared
pHAT
pHAT
VIN
3.3V
GND
GND
SCL
SCL
SDA
SDA
Humidity Sensor
Humidity Sensor
The official humidity temperature for ANAVI Infrared pHAT is HTU21 (SHT21). This is I2C sensor capable of measuring both humidity and temperature.
Using 4 Dupont jumper wires connect HTU21 to one of the 3 I2C slots on ANAVI Infrared pHAT as follows:
HTU21
HTU21
ANAVI Infrared
ANAVI Infrared
pHAT
pHAT
VIN
3.3V
GND
GND
SCL
SCL
SDA
SDA
