Analytik Jena CyBio Well vario OL3381-25-300, Operating Manual

Page: 136 / 164

120 Release: 2017 CyBio
®
Well vario
Maintenance & Care
5. Install the capillary magazine back into the capillary head and press "Enter" key
at the control panel. The capillary magazine will be clamped again.

Its capillaries have been replaced.
9.2.6 Cleaning the Carriage (Linear Transporting Unit)
To clean the carriage, proceed as follows:
1. Turn CyBio
®
Well vario power off at the main power switch, then disconnect the
power plug from the socket.
2. Remove tip magazine from pipetting head for safety reasons (
→
refer to page
117 ).
3. Remove all microplates, reservoirs or washing troughs.
4. Remove carriage from the transport rails by raising it at the front and the back
end by equal amounts simultaneously. Proceed with due care, in order to prevent
damage.
5. Clean the carriage and transport rails using a mild detergent or disinfectant.
6. Carefully place the carriage back onto the transport rails.
7. Carefully push the tip magazine back into the holder at the pipetting head. Make
sure that tip magazine is correctly placed on completion of work.
8. Reconnect power plug to mains socket and turn CyBio
®
Well vario power on at
the main switch.

The system will be re-initialized and become operational again.
9.2.7 Cleaning the Rotary Table (Circular Transporting Unit)
To clean the rotary table, proceed as follows:
1. Turn CyBio
®
Well vario power off at the main power switch, then disconnect the
power plug from the socket.
2. Remove tip magazine from pipetting head for safety reasons (
→
refer to page
117 ).
3. Remove all microplates, reservoirs or washing troughs.
4. Clean the rotary table using a mild detergent or disinfectant.
5. Carefully push tip magazine back into the holder at the pipetting head. Make
NOTE
Carriage performance depends on the current state of the transport rails. Remove pock-
ets of dirt, contamination or damage of transport rails immediately.
Spitzenwechsel
Spitzen anziehen