RC400T
Ref. RC400T
QUICK START GUIDE
Thank you for choosing
Analog Way
and the
RC400T
. By following these simple steps, you will be able to set
up and use your event controller for LivePremier™ 4K/8K multi-screen presentation system within minutes.
• 1 x
RC400T
• 1 x Power supply cord
• 1 x XLR lamp (optional)
• 1 x Quick start guide*
* User manual and Quick start guides are also available on
www.analogway.com
The
RC400T
event controller has been designed to greatly increase the level of operational efficiency and
to give instant access to the crucial functionalities of the LivePremier™ image processor such as screens,
layers, sources and memories. The
RC400T
offers 56 user programmable buttons, a high-resolution T-bar
and a three-axis joystick for easy and fast programming (assign source in layers, load memories, etc.).
WHAT’S IN THE BOX
OVERVIEW
INSTALLATION
The
RC400T
has been designed to be used directly on a table. It is equipped with a wrist rest and four anti-
slip rubber feet. The wrist rest can be removed for a recessed installation of the RC400T.
• Recessed installation - Remove the wrist rest
1. Turn the rear panel power switch off and disconnect the power supply.
2. Remove the screws of the wrist rest on both sides of the
RC400T
using a T10 Torx screwdriver.
3. Safely remove the wrist rest.
The
RC400T
is ready for recessed installation. Before embedding the
RC400T
, connect all cables and turn
the rear panel power switch on or make sure they can be accessed.
RC400T
dimensions:
- L 570 mm x H 122.5 mm x P 382 mm (W 22.44’’ x H 4.82’’ x D 15.04’’)
FIRMWARE UPGRADE
Download the
RC400T
updater and the latest LivePremier™ firmware on
www.analogway.com
1. Put the updater file on a USB drive.
2. Connect the USB drive on the front panel.
3. The updater file is automatically detected. Otherwise, go to
Console Control
>
Update from USB
.
4. Extract the updater file.
5. Install the new firmware.
Go on our website to register your product(s)
and be notified about new firmware versions:
Register
your product
