19
USER MANUAL
USER MANUAL
USER MANUAL
USER MANUAL
USER MANUAL
USER MANUAL
USER MANUAL
USER MANUAL
4.5
Fixed parts
The following parts are fixed and available on all LivePremier units (except the second Power supply unit on
4RU units).
Warning
: - All parts other than input and output cards are fixed and should not be removed.
Fig. 3 -
Fixed parts on all LivePremier units
USB and sync ports
All LivePremier units are equipped with four USB ports (two on the front panel, two on the rear panel).
The sync ports can be used to synchronize LivePremier units with other devices.
Note: All sync ports are independent and can be used equally.
Framelock
A Framelock is used to synchronize the frame rate of multiple devices with a physical connection.
-
The Framelock input is used to synchronize the LivePremier unit with an external reference.
-
The Framelock loop connector is then used to send the sync signal to other devices.
-
The Framelock output can also be used alone (as a sync signal generator).
GPIO
All LivePremier units are equipped with 3x MCO 5 pin connectors:
- 1x On/Off
- 2x GPI
- 8x GPO
Note: For more information on GPIO settings, see
Dante audio connectors
All LivePremier units are equipped with two dedicated Dante connectors to support up to 64 (8x8) audio
input channels and 64 (8x8) audio output channels at 48 kHz.
Dante audio can only be controlled from the Dante ports used as primary & secondary connections.
The Dante network is a network dedicated to audio and separated from the LivePremier network.
Note: For more information on Audio settings, see
page 65.
