Analog Devices UG-200, User Manual

Page: 7 / 28

Evaluation Board User Guide UG-200
Rev. 0 | Page 7 of 28
09436-
006
COLLAPSE DISPLAY BUTTON
Figure 6. VisualAnalog, Main Window Expanded Display
4. Program the FPGA of the HSC-ADC-EVALCZ board to a
setting other than the default setting as described in Step 3.
Then expand the VisualAnalog display and click the
Settings
button in the ADC Data Capture block (see Figure 6). The
ADC Data Capture Settings box opens (see Figure 7).
09436-
007
Figure 7. ADC Data Capture Settings, Capture Board Tab
5. Select the Capture Board tab and browse to the appropriate
programming file. Next, click Program ; the DONE LED, D6,
in the HSC-ADC-EVALCZ board should then turn on.
6. Exit the ADC Data Capture Settings box by clicking OK .
Setting Up the SPI Controller
After the ADC data capture board setup has been completed,
set up the SPI Controller:
1.
Open the SPI Controller software by going to the Start
menu or double-clicking the SPI Controller software
desktop icon. If prompted for a configuration file, select
the appropriate one. If not, check the title bar at the top of
the SPI Controller window to determine which configura-
tion is loaded. If necessary, choose
Cfg Open from the File
menu and select the appropriate configuration. Note that
the
CHIP ID(1) field should be filled to indicate whether
the correct SPI Controller configuration file is loaded (see
Figure 8).
09436-
008
Figure 8. SPI Controller, CHIP ID(1) Box
2. Click the New DUT button in the SPI Controller (see
Figure 9).
09436-
009
NEW DUT BUTTON
Figure 9. SPI Controller, New DUT Button
3. Click the Run button in the VisualAnalog toolbar (see
Figure 10).
09436-
010
RUN BUTTON
Figure 10. VisualAnalog Window Toolbar, Run Button