Analog Devices SHARC ADSP-21375, Manual

Page: 89 / 89

INDEX
I-4 ADSP-21375 EZ-KIT Lite Evaluation System Manual
SDRAM
chip select pin (FLAG8), 2-6
controller, 1-8
control signals, 2-7
via external port, 2-3
serial peripheral interface, See SPI
setup, of this EZ-KIT Lite, 1-3
signal routing units
SRU2 (DPI interface), 2-5
SRU (DAI interface), 2-4
spacing headers, 2-24
SPI
flash memory, 1-7 , 1-8 , 2-6
master/slave boot modes, 2-3 , 2-10
port, 1-8 , 1-10
startup, of this EZ-KIT Lite, 1-5
SW12 (reset) push button, 2-17
SW13 (ELVIS station) switch, 2-14
SW14 (test) switch, 2-12
SW15 (AD1835A and flash disconnect) switch,
2-15
SW1 (oscilloscope) switch, 2-13
SW2 (boot mode select) switch, 2-3 , 2-6 , 2-10
SW3 (AD1835A codec) switch, 2-5 , 2-11
SW4 (microphone) switch, 1-11 , 2-12
SW6 (test) switch, 2-12
SW7 (push button enable) DIP switch, 1-4 ,
1-11 , 2-13 , 2-17
SW8-11 (general input) push buttons, 2-17
synchronous dynamic random access memory,
See SDRAM
system architecture, of this EZ-KIT Lite, 2-2
T
test switches (SW6, SW14), 2-12
time-division multiplexed (TDM) mode, 1-10
two-wire interface (TWI) mode, 1-10
U
UART
enable switch (SW5)
interface,
xi , 2-6
universal asynchronous receiver/transmitter, See
UART
USB
cable, 1-3 , 1-5 , 2-16 , 2-17
interface, 2-8 , 2-25
interface chip (U34), 2-17
monitor LED (ZLED3), 1-5 , 2-16
V
Vi+
environment, 1-5
voltage-controlled oscillator select jumper (JP1),
2-19