4
dc2691af
DEMO MANUAL DC2691A
QUICK START PROCEDURE
The DC2691A programming board makes it easy to pro-
gram and verify the EEPROM contents of the device.
1. Place jumpers and switches in the following default
positions.
WP: OFF
ASEL1: L
ASEL0: L
S1: OFF
NOTE: By default, ASEL0 and ASEL1 jumpers are both
set to low (L). If you wish to program a device with
an address other than 0x5C, adjust ASEL0 and ASEL1
jumpers appropriately. Consult device data sheet for
details.
2. Connect USB controller to your PC. Plug the ribbon
cable into connector J1 of the DC2691A programming
board.
3. Open the socket lid. Place the IC inside with pin 1
located in the upper left corner. See Figure 4.
Figure 4. Open Clamshell Lid
