EVAL-ADV7180EB Application Note Video Group Limerick
Introduction
The ADV7180 is available in three packages, 64-pin LQFP, 40-pin LFCSP and 32-pin
LFCSP. The EVAL-ADV7180LFEBZ employs the 40-pin LFCSP packaged decoder, the
EVAL-ADV1780LQEBZ employs the 64-pin LQFP packaged decoder, and the EVAL-
ADV7180-32EBZ employs the 32-pin LFCSP packaged decoder. This application note
is intended to provide application support for the ADV7180 evaluation boards. This
document contains a description of the evaluation kit and the evaluation boards. It also
provides details on setup and configuration for evaluation.
Evaluation Kit
Each ADV7180EB evaluation kit consists of the following:
•
ADV7180 Evaluation board
•
ADV7180 Evaluation Kit CD
•
I2C Download cable with USB port connector.
•
7V DC Power Supply Module.
Initial Configuration.
Register Control Software
1.
Install the Register Control software from the evaluation CD. (Please refer to the
Installation Guide on the evaluation CD for step-by-step instructions.)
2.
Once the software is installed, power up the board and connect the USB
connector.
3.
Start the application
(START>PROGRAM>.ADVREGISTER CONTROL
>ADVREGISTER CONTROL 3.56).
The ADV Register Program Configuration screen appears, as shown in Figure 1
Rev.B November 2009
Analog Devices B.V.
3 of 54
