Analog Devices EVAL-ADN469xEFDEBZ, User Manual

Page: 4 / 9

UG-1256 EVAL-ADPD188GGZ User Guide
Rev. 0 | Page 4 of 9
If the firmware must be updated, take the following steps:
1. Download and install the latest DfuSe USB device
firmware upgrade software.
2. Plug in a microUSB cable between the EVAL-
ADPDUCZ and the PC with the power to the EVAL-
ADPDUCZ turned off (see Figure 6).
3. Press and hold the BOOT0 button, and switch the power
switch to the ON position (see Figure 6).
BOOT0
BUTTON
16617-
006
Figure 6. MicroUSB Connection and BOOT0 Button Used When Upgrading
Firmware
4. Go to Device Manager > Universal Serial Bus
controllers and wait until the PC detects STM Device
in DFU Mode (see Figure 7).
16617-
007
Figure 7. STM Device in DFU Mode Displayed
5. Release the BOOT0 button.
6. Open the DfuSe Demo by going to Start > All
Programs > STMicroelectronics > DfuSe > DfuSe
Demo . Figure 8 shows the DfuSe demo settings at
startup.
7. In the Upgrade or Verify Action section, click Choose ,
and select the Adpd_M4_uC.dfu file from the Firmware
folder of the downloaded software package.
8. Click Upgrade and follow the prompts to upgrade the
firmware of the EVAL-ADPDUCZ microcontroller
board.
After the firmware is updated, connection to the Applications
Wavetool can be completed.
16617-
008
Figure 8. DfuSe Demo Settings
USB UART CONNECTION
To establish the connection, follow the menu path Connection >
Connect > UART Bridge .
16617-
009
Figure 9. UART Connect
Select the proper COM port to connect the Applications Wavetool
to the device. If connection via Bluetooth® is required, or if there are
any other connection issues, refer to the Applications Wavetool
user guide that is provided in the software package download.