Analog Devices EVAL-ADN469xEFDEBZ, User Manual

Page: 3 / 9

EVAL-ADPD188GGZ User Guide UG-1256
Rev. 0 | Page 3 of 9
GETTING STARTED
INSTALLING THE APPLICATIONS WAVETOOL
Download the Applications Wavetool software package from the
EVAL-ADPD188GGZ product page at
www.analog.com/EVAL-
ADPD188 . Unzip the folder and run the Applications Wavetool
executable file. Follow the prompts, beginning with the setup
window shown in Figure 2 for software installation.
16617-
002
Figure 2. Applications Wavetool Setup Window
CONNECTING THE EVAL-ADPDUCZ
MICROCONTROLLER BOARD AND THE EVAL-
ADPD188GGZ EVALUATION BOARD
Connect the USB cable to the EVAL-ADPDUCZ evaluation board,
connect the ribbon cable to the EVAL-ADPD188GGZ board,
and switch the power switch to the ON position (see Figure 3).
When the USB cable is connected, the second light emitting
diode (LED) below the power switch illuminates, indicating that
the on-board battery is being charged. When the power switch is
turned to the
ON position, the LED immediately below the power
switch illuminates, indicating that the EVAL-ADPDUCZ
microcontroller board is on.
SWITCH
TO ON
16617-
003
Figure 3. Connect the EVAL-ADPDUCZ to the EVAL-ADPD188GGZ
CHECKING THE USB SERIAL CONNECTION IN
WINDOWS®
Ensure that the COM port driver is installed correctly. To verify
proper installation, go to
Control Panel > All Control Panel
Items > System > Device Manager , as shown in Figure 4. In this
case, the proper COM port selection is USB Serial Port (COM16) .
The EVAL-ADPDUCZ microcontroller board uses an FT232 USB
universal asynchronous receiver transmitter (UART) IC. If the
USB driver installation does not install properly, refer to the
corresponding Future Technology Devices International (FTDI)
driver installation guide to the operating system in use.
16617-
004
Figure 4. USB Serial Port in Windows 7
RUNNING THE APPLICATIONS WAVETOOL
To start the Applications Wavetool application, go to Start >
Analog Devices > ApplicationsWavetool and click
ApplicationsWavetool.
INSTRUCTIONS TO LOAD THE FIRMWARE
The EVAL-ADPDUCZ microcontroller board may have an older
version of the firmware installed during manufacture. In this case,
the user receives the message shown in Figure 5 when trying to
connect to the Applications Wavetool.
16617-
005
Figure 5. Warning Message for Outdated Firmware