Analog Devices EVAL-ADIN1100EBZ, User Manual

Page: 6 / 11

User Guide EVAL-ADIN1100
HARDWARE
analog.com Rev. 0 | 6 of 11
Table 3. Default Firmware Mode Configuration, S403 (Labeled uC CFG)
1
Switch Position Switch Name Default Position
1 CFG_0 Off
2 CFG_1 Off
3 CFG_2 Off
4 CFG_3 Off
1
Mode 15 media converter (default positions for S403 when shipped). All switches off. See Table 6 .
Table 4. ADIN1100 Hardware Configuration, S201 (Labeled HW CFG)
Switch Position
Switch Name Default Position Description
1 MEDIA_CNV Off Media converter (only for RMII interface mode, not used on this board)
2 MACIF_SEL1 Off MAC Interface Select 1
3 SWPD_N Off Software power-down
4 MACIF_SEL0 On MAC Interface Select 0
5 TX2P4_DIS Off Transmit amplitude 2.4 V disable (always turn this switch on if AVDD_H = 1.8 V
6 MS_SEL Off Master/slave select (used as preference for autonegotiation)
7 PHYAD_0 Off PHY Address 0 for management interface (MDIO)
8 PHYAD_1 Off PHY Address 1 for management interface (MDIO)
Table 5. Board LED Indicators
Name
Colour Reference Designator Description
uC0 Green LED400 In media converter mode, uC0 indicates media converter is working and both PHY links are up
uC1 Red LED401 Error detected by firmware
uC2 Yellow LED402 Short flash: heartbeat
Long flash or on: receiving UART commands
uC3 Blue LED403 Reserved
LED_0 Green LED200 10BASE-T1L link up/activity
LED_1 Yellow LED201 In firmware managed modes: 10BASE-T1L transmit amplitude 2.4 V
RJ45 Green P5 10BASE-T link up
RJ45 Yellow P5 10BASE-T activity
POWER Green LED1 Board 3.3 V power supply is present