Analog Devices EVAL-ADGS5412SDZ, User Manual

Page: 5 / 12

EVAL-ADGS5412SDZ User Guide UG-1141
Rev. 0 | Page 5 of 12
EVALUATION BOARD SOFTWARE
INSTALLING THE SOFTWARE
The EVAL-ADGS5412SDZ evaluation board uses the Analog
Devices
Analysis Control Evaluation (ACE) software. ACE is a
desktop software application that allows the evaluation and
control of multiple evaluation systems.
ACE installs the necessary SDP drivers and .NET Framework 4
by default. Install ACE before connecting the SDP. The ACE
software and access to full instructions on how to install and
use
ACE can be found on the Analog Devices website.
After the installation is finished, the EVAL-ADGS5412SDZ
evaluation board plug-ins appear when opening
ACE .
INITIAL SET UP
To set up the evaluation board, complete the following steps:
1. Connect the evaluation board to the SDP board and
connect the SDP board to the computer via a USB cable.
2. Power the evaluation board as described in the Power
Supplies section.
3. Run the ACE application. The EVAL-ADGS5412SDZ
board plug-ins appear in the attached hardware section of
the
Start tab.
4. Double-click on the evaluation board plug-in to open the
evaluation board view seen in Figure 2.
5. The chip block diagram can be accessed by double-clicking
on the
ADGS5412 icon (see Figure 2). This view provides a
basic representation of functionality of the evaluation board.
The main functions are labeled in Figure 3.
Figure 2. Evaluation Board View of the EVAL-ADGS5412SDZ
Figure 3. Chip Block Diagram View for the ADGS5412
1589
6-
002
1
589
6-
0
03