User Guide
UG-1268
Rev. A | Page 5 of 22
EVALUATION SOFTWARE QUICK START PROCEDURES
PLUG-INS
The EVAL-AD5758SDZ software uses the Analog Devices, Inc.,
software. For instructions the use of the
software, see
product page.
When the installation completes, the EVAL-AD5758SDZ eval-
uation board plug-in appears when the
software opens
16
710
-002
Figure 2. EVAL-AD5758SDZ Evaluation Board Plug-In Window after Opening
INITIAL SETUP
To set up the EVAL-AD5758SDZ, take the following steps:
1.
Connect a USB cable to the PC and then to the
board.
2.
Connect the
board to the EVAL-AD5758SDZ. The
PC recognizes the EVAL-AD5758SDZ.
3.
Power up the EVAL-AD5758SDZ with the relevant power
supplies.
4.
If not opened already, open the
software. The EVAL-
AD5758SDZ appears in the
Attached Hardware
pane.
16
71
0-
0
03
Figure 3. EVAL-AD5758SDZ Plug-In Not Installed
5.
When setting up the evaluation board for the first time, the
EVAL-AD5758SDZ plug-in may need to be installed. If the
plug-in appears as shown in Figure 6, go to Step 7. If the plug-
in appears as shown in Figure 3, click the button that is circled
in red in Figure 3. After clicking this button, the pop-up
window shown in Figure 4 appears. Click
Yes
.
16
710
-00
4
Figure 4. Installing Plug-In Pop-Up Window
6.
A new window appears, as shown in Figure 5. Navigate to
the
Board.AD5758
plug-in and click
Install Selected
. The
EVAL-AD5758SDZ plug-in installs and is displays, as
shown in Figure 6.
1671
0-
20
5
Figure 5. Plug-In Manager Window
16
71
0-
2
06
Figure 6. Attached Hardware Pane with EVAL-AD5758SDZ Connection
