13
Rev. 0
SOFTWARE SETUP
7. Upload the
DC2515_New
sketch onto the DC2026 by clicking on the
Upload
button on the top left corner. When
this process is completed there will be a “Done uploading” message on the bottom left corner.
8. Open the Arduino
Serial Monitor
tool. Click on the
Serial Monitor
button on the top right corner then the
Serial
Monitor
window will open and show on the top left corner the
COMxx
used.
9. Configure the
Serial Monitor
to allow communication to the DC2026 through USB. On the bottom of the
Serial
Monitor
window, set the following starting from bottom left to bottom right:
a. Click on the
Autoscroll
checkbox for the “
” check mark symbol.
b. Select
Both NL & CR
on the left dropdown menu.
c. Select
115200 baud
on the right dropdown menu.
d. As shown below, when configured correctly the
DC2515_New
sketch menu will appear.