ADV8005 Hardware Reference Manual
UG-707
blank_level_u[11:0]
, IO Map,
Address 0x1A26[7:0]; Address 0x1A27[7:4]
This signal is used to adjust the blank level of u input to the vid adjust block.
Function
blank_level_u[11:0]
Description
0x000
u blank level sits at code 0
0x800 (default)
u blank level sits at code 2048 decimal
blank_level_v[11:0]
, IO Map,
Address 0x1A27[3:0]; Address 0x1A28[7:0]
This signal is used to adjust the blank level of v input to the vid adjust block
Function
blank_level_v[11:0]
Description
0x000
v blank level sits at code 0
0x800 (default)
v blank level sits at code 2048 decimal
Figure 33: Saturation Processing
Refer to Section
for more information on the CSC controls for the primary input channel.
Refer to
Section
for more information on the ACE controls for the primary input channel.
2.2.2.7.
Secondary Input Channel
The
secondary input channel incorporates an input formatter, CSC and updither block.
The input formatter provides a number of controls to configure what data the secondary input channel is configured for. The secondary input
channel must be connected to either the video TTL input pins or the EXOSD TTL input pins using
channel is connected to the video TTL input pins, the format and bit width of the data, for example, 2 x 8 bit buses of 4:2:2 data, must be specified
using
can be used to indicate which input pins are used to carry the upper, middle and lower
ranges of bits (for example, upper = D[35:25], middle = D[24:12], lower = D[11:0]; or upper = D[11:0], middle = D[35:25], lower = D[24:12]).
s_inp_chan_sel[1:0]
, IO Map,
Address 0x1A07[3:2]
This signal is used to select the input for the Secondary Input Channel.
Function
s_inp_chan_sel[1:0]
Description
00
Video TTL input (P[35:0])
01 (default)
EXOSD TTL Input (OSD_IN[23:0])
10
RX video
11
N/A
-
*
+
blank_level_u/v
saturation
blank_level_u/v
u/v_out
u/v_in
Rev. A | Page 57 of 317