Analog Devices ADSP-TS201S EZ-KIT Lite, Manual

Page: 54 / 92

LEDs and Push Buttons
2-18 ADSP-TS201S EZ-KIT Lite Evaluation System Manual
USB Monitor LED (ZLED3)
The USB monitor LED indicates that USB communication has been ini-
tialized successfully, allowing you to connect to the processor using
Vi+. If
ZLED3
is not lit, try resetting the board and/or reinstalling
the USB driver.
L
When Vi+ is communicating with the EZ-KIT Lite tar-
get board, the LED can flicker, indicating communications
handshake.
Programmable FLAG Push Buttons (SW6–9)
Four push buttons are provided for general-purpose user input. The
SW6–9
push buttons connect to the processor’s programmable
FLAG
pins. The
push buttons are active high and when pressed, send a high (
1
) to the pro-
cessor. Refer to “Programmable FLAG Pins” on page 1-10 for more
information on how to use the flags. Table 2-19 shows the
FLAG
signals
and corresponding switches.
Table 2-18. FLAG LEDs
FLAG Pin LED Reference Designator FLAG Pin LED Reference Designator
FLAG2_A LED4 FLAG2_B LED5
FLAG3_A LED6 FLAG3_B LED3
Table 2-19. FLAG Push Buttons
FLAG Pin Push Button Reference Designator
FLAG0_A SW9
FLAG1_A SW8
FLAG0_B SW6
FLAG1_B SW7