ADSP-CM403F EZ-KIT Lite Evaluation System Manual
1-5
Using ADSP-CM403F EZ-KIT Lite
IAR Embedded WorkBench and Board
Installation
For information about the IAR Embedded WorkBench
®
product and
software download, go to:
http://www.iar.com/en/Products/IAR-Embedded-Workbench
The ADSP-CM403F EZ-KIT Lite software, based on the IAR Embedded
WorkBench, can be found at:
http://www.analog.com/CM403FEZKit
Follow these instructions to ensure correct operation of the product soft-
ware and hardware.
Step 1:
Connect the EZ-KIT Lite board to a personal computer (PC) run-
ning
IAR Embedded WorkBench
using a J-Link/J-Trace emulator.
1. Plug one side of the USB cable into the USB connector of the emu-
lator. Plug the other side into a USB port of the PC running
IAR
Embedded WorkBench
.
2. Attach the emulator to the header connector,
P1
or
P2
, on the
EZ-KIT Lite board.
Step 2:
Attach the provided cord and appropriate plug to the 5V power
adaptor.
1. Plug the jack-end of the power adaptor into the power connector
P7
(labeled
5V
) on the EZ-KIT Lite board.
2. Plug the other side of the power adaptor into a power outlet. The
power LED (labeled
LED5
) is lit green when power is applied to the
board.
