Analog Devices ADSP-21992 EZ-KIT LITE, System Manual

Page: 35 / 87

ADSP-21992 EZ-KIT Lite Evaluation System Manual 1-15
Getting Started
4. Verify the installation by following the instructions in “Verifying
Driver Installation” on page 1-15 .
Verifying Driver Installation
Before you use the EZ-KIT Lite evaluation system, verify that the USB
driver software is installed properly:
1. Ensure that the USB cable is connected to the evaluation board and
the PC.
2. Press the RESET button (
S1
) on the evaluation board.
3. Verify that the red USB monitor LED (CR7) is lit. This signifies
that the board is communicating properly with the host PC, and is
ready to run Vi+.
Figure 1-10. Completing Driver Installation