Analog Devices ADSP-2189M EZ-KIT Lite, Manual

Page: 39 / 81

ADSP-2189M EZ-KIT Lite Evaluation System Manual 2-15
Using EZ-KIT LITE Software
Setting Breakpoints and Stepping
The debugger automatically inserts breakpoints at the function
main()
,
when the Settings , Run To Main command is checked, and at the
_exit
instruction.
#
Breakpoints set in the last three instructions of a do-loop are
allowed, but this causes improper debugger operation.
Resetting EZ-KIT Lite Board
The EZ-KIT Lite board can be reset with the push button,
SW2
, switch on
the board or with the Debug , Reset command in the debugger. After per-
forming a reset, reload any programs you were running. The Debug ,
Restart command also resets the processor. The processor, however,
retains all debug information and memory contents.
The following sequence must be used when starting the debugger:
1. Start Vi+ from the Windows Start menu.
The debugger starts and the Target message Hit Reset Button
appears.
2. Press the reset button. Wait approximately three seconds for the
LEDs (except the power LED) to go dark.
3. Click OK .
#
Do not use the reset button while the debugger is open unless the
debugger requested to do so.