Analog Devices ADP8860SHIELD-EVALZ, User Manual

Page: 5 / 16

ADP8860SHIELD-EVALZ / ADP8861SHIELD-EVALZ User Guide UG-1888
Rev. 0 | Page 5 of 16
EVALUATING THE ADP8860SHIELD-EVALZ OR THE ADP8861SHIELD-EVALZ
EVALUATION SUMMARY
All required software, such as the CrossCore Serial Flash
Programmer 1.5.0
, GUI installers for Windows and Android
devices, and source code (hex file) for the embedded target
are provided on the ADP8860SHIELD-EVALZ and the
ADP8861SHIELD-EVALZ webpages. Before loading any new
firmware to the
EV-COG-AD3029LZ , clean and build the target
and connect the EV-COG-AD3029LZ microcontroller to one
of the ports on the Windows PC. Once the source code shown in
Figure 6 loads, reset the EV-COG-AD3029LZ to ensure that the
system, which includes the ADP8860SHIELD-EVALZ or the
ADP8861SHIELD-EVALZ and the EV-COG-AD3029LZ, properly
works. Once the source code is set up, open the GUI application
on the specific machine being used.
Note that flashing the embedded target (EV-COG-AD3029LZ)
can only be done using a Windows machine for this user guide.
WINDOWS APPLICATION
Within the Windows application, users must take the following
firmware, hardware, and GUI steps to evaluate the
ADP8860SHEILD-EVALZ or the ADP8861SHEILD-EVALZ.
Flashing Firmware
To flash the firmware, take the following steps:
1. Open the CrossCore Serial Flash Programmer 1.5.0 app.
If the programmer is not installed, download the installer
from the
CrossCore Utilities webpage.
25186-
004
Figure 4. CrossCore Serial Flash Windows App
2. Ensure that the EV-COG-AD3029LZ is connected and
select the following parameters (see Figure 5):
a.
Target : ADuCM302x
b. Serial Port : (Port where the board is connected)
c. Baudrate : 115200
d. Action : Program
25186-
005
Figure 5. CrossCore Serial Flash Programmer Window
3. Under the File to download tab, browse and choose the
source code (hex file) along with the downloaded files
from the ADP8860SHIELD-EVALZ or the
ADP8861SHIELD-EVALZ webpage.
251
86-
007
Figure 6. Package File Structure
4. Click Start to flash the programmer to the EV-COG-
AD3029LZ.
Hardware
To verify and reset the hardware, take the following steps:
1. Ensure that the GPIO28 pin on the EV-GEAR-
EXPANDER1Z is not connected to GND. Remove
any connection or jumpers if there is any.
25
186
-008
Figure 7. EV-COG-AD3029LZ with EV-GEAR-EXPANDER1Z Top View
2. Do a hardware reset on the ADP8860SHEILD-EVALZ
or the ADP8861SHEILD-EVALZ and the EV-COG-
AD3029LZ to reboot the flashing firmware.