Quick Start Guide
AD9741/3/5/6/7-EBZ
©2009 Analog Devices, Inc. All rights reserved. Trademarks and
registered trademarks are the property of their respective owners.
D00000-0-1/07
Using the AD9741/AD97473/AD9745/AD9746 Evaluation Boards
The evaluation boards for the AD9741/AD97473/AD9745/AD9746/AD9747 are identical except for the DUT installed. The operation of
the eval boards is also the same except for the vector generation “DAC Resolution” field and the Data Width fields as shown below.
These fields should be configured to match the DUT.
Selecting the Modulator Outputs
By default, solder jumpers JP4, JP5, JP6, and JP7 configure the DAC outputs to be observed at SMA outputs J5 and J9. This jumper
setting is shown in Figure 4 a). To connect the DAC outputs to the LPF and the ADL537x analog quadrature modulator, the solder
jumpers need to be repositioned as shown in Figure 4 b). The modulator output can be observed thru the SMA connector J6
(MODULATED OUTPUT). The modulator LO input can be sourced thru SMA connector J10 (LOCAL OSC INPUT). The clock level
into the modulator should be set to about 3dBm.
Figure 4 – a) DAC Output
Configuration
b)
Modulator Output Configuration
