For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).
4/10
©2010 AMX. All rights reserved. AMX and the AMX logo are registered trademarks of AMX.
AMX reserves the right to alter specifications without notice at any time.
3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com
93-1402-70
REV: B
Using the UDM-RC05 for Video Compensation
The UDM-RC05 can also be used with UDM-RX02N receivers for video
compensation (FIG. 2):
Note
: In order to use the UDM-RC05 to compensate video on the UDM-RX02N,
the RX02N must be set to the AMX remote, via the "
RP
" command (see below).
• Enter setup mode - press MENU, then AMX
• Exit setup mode - EXIT
• Red skew increase - RED
• Green skew increase - GREEN
• Blue skew increase - BLUE
• Gain (brightness) - LEFT and RIGHT
• Sharpness - UP and DOWN
“RP” SEND_COMMAND
• Device SEND_COMMANDS are sent to
Port 1
on the UDM-RX02N.
• All text is based on a Unicode index.
Additional Documentation
For detailed programming information as well as installation and c
onfiguration
instructions for the UDM-0808-SIG and UDM-RX02N, refer to the
UDM-0808-SIG, UDM-RX02N & UDM-ABB-8-SIG Operation/Reference Guide
(available at www.amx.com).
FIG. 2
UDM-RC05 IR Remote Control - Video Compensation buttons
“RP” SEND COMMANDs (UDM-RX02N)
"'RP<P#>'"
Sets the protocol
used by the IR remote.
The Rx can support a number of different remotes which
are mapped through to button pushes
Syntax:
SEND_COMMAND <DEV>, "'RP<P#>'"
Variables:
• P#:
"ENDELEO", "AMX", "SKY", "TIVO", "DIRECTV",
"MIOR1", "MIO", "RC02", "RC05"
Example:
SEND_COMMAND dvRX, "'RPRC05'"
Configures the Rx to use an AMX remote.
The available remotes are:
• ENDELEO, RC02 - grey 33 button or 13 button remotes
• AMX, RC05 - beige 43 button
• SKY - Sky satellite remote
• TIVO - standard Tivo remote
• DIRECTV - standard DirecTV remote
• MIOR1 - AMX R1 remote
In all the above cases, the push and release codes are
endeleo codes.
MIO - AMX R1 remote - this setting uses all 255 push/
release codes.
"'?RP'"
Returns the protocol
used by the IR remote.
The Rx can support a number of different remotes which
are mapped through to button pushes.
Syntax:
SEND_COMMAND <DEV>, "'?RP'"
Example:
SEND_COMMAND dvRX, "'?RP'"
The port would respond with RP-ENDELEO.
Red skew increase
Green skew increase
Blue skew increase
Gain (Brightness)
Press
MENU
then
AMX
to enter Setup mode
Press
EXIT
to exit Setup mode
Sharpness
