AMX TX64, Instruction Manual, Page: 13 / 16

TX64 64-Button Transmitter Troubleshooting 9
Troubleshooting
Overview
Read through the following information (Figure 6) if you are experiencing a
problem with your transmitter. If the problem cannot be resolved, refer to the
Technical Support section of this manual.
Troubleshooting
Problem Action
Red transmission LED does
not flash when you press a
transmitter pushbutton. Remove the transmitter's battery cover and verify the battery is
installed correctly.
Verify the battery is fully charged using a voltage tester. If not,
replace the battery.
If the transmission LED in the TX64 does not flash and one (or
both) of the following conditions are true, replace the
transmission LED or return the unit to AMX for repair.
•
RF system receiver responds correctly when you press a
transmitter pushbutton.
•
RF receiver LED lights when you press a transmitter
pushbutton.
Red LED flashes but your
AMX system does not
respond. Verify the transmitter channel group matches the receiving
control system's channel group.
Hold the transmitter closer to the RF receiver. If the problem
stops, the transmitter signals cannot reach the control system
due to high levels of RF interference.
Figure 6
Troubleshooting