AMX TPI-PRO-4, Operation/Reference Manual

Page: 70 / 218

TPI-PRO/DVI Configuration Pages
64 TPI-PRO/DVI (Total Presentation Interface)
Supported Sampling Rates for WAV and MP3 Audio
The TPI-PRO/DVI supports WAV and MP3 audio types, at the following sample rates:
Setup - Video Settings Page
Press the Video button on the Setup Page (see FIG. 58 on page 58) to access the Video Settings Page. The
options in the Video Settings page allow you to configure the properties of the incoming video signal(s).
This page features up to four tabs (SLOT 1 - SLOT 4) - one for each source input on the TPI-PRO/DVI. If you
are using a TPI-PRO/DVI-2 (which features two inputs), then the tabs for Slots 3 and 4 are disabled.

These source inputs are labeled at the rear of the TPI-PRO/DVI (Input N ).

The Input type ( Composite , S-Video , Computer (VGA) , Component (YPrPb), or DVI ) must be set
for each input.
The options presented on this page differ according to the Input type selected:

If you have selected VGA or Component as the Input Type, the Video Settings Page contains the
options shown in FIG. 63.
Setup - Audio Settings Page (Cont.)
Default Panel
Sounds: Sets the unit to play either the default Button Hit sound (when you touch an active button)
and/or the default Button Miss sound (when you touch a non-active button or any area
outside of the active button).
By default, Button Hit sound is enabled , and Button Miss sound is disabled .
Supported WAV / MP3 Audio Sample Rates
• 48000Hz
• 44100Hz
• 32000Hz
• 24000Hz
• 22050Hz
• 16000Hz
• 12000Hz
• 11025Hz
• 8000Hz
FIG. 63 Setup - Video Settings Page (Input Type = VGA or Component)
Incoming Video Signal
window