AMX TDS, Operation/Reference Manual

Page: 14 / 106

AMX TDS - ClearQAM/ATSC (High Definition)
6 AMX TDS (Television Delivery System)
Rear Panel - 10/100 Network Port
The 10/100 (Ethernet RJ45) port on the front panel provides 10/100 BaseT network connectivity via
Cat5/5e/6 network cable (FIG. 7). Refer to the
Connecting the Transmitters to the Network section on page 17
for more information.
10/100 Network Port Pinouts and Signals
The following table lists the pinouts, signals, and pairing for the 10/100 Network port.
FIG. 8 diagrams the pinouts and signals for the 10/100 Port RJ45 connector and cable. Note that while 568B
termination is shown in the figure, 568A can also be used, as long as both ends are terminated the same way.
Consult the Network Administrator for correct cabling from the DTV-TX03-US Transmitter onto the network.

For remote connectivity, the Firewall may have to be configured to open port 2008 for remote
connectivity over UDP.

Ports 5000 and 5001 are required for the Transmitters as well as any ports used for the TDS
Multicast stream.

Ports 5002 and 5003 are fixed as the multicast stream output ports.
FIG. 7 10/100 Ethernet Port
Cat5/5e/6 network cable
DTV-TX03-US Transmitters require Layer 3 switching. Therefore a Layer 3 Network
Switch (sometimes referred to as a "Multilayer Switch") is required to operate
properly.
10/100 Port Pinouts and Signals
Pin Signals Connections Pairing Color
1 TX + 1 --------- 1 1 --------- 2 Orange-White
2 TX - 2 --------- 2 Orange
3 RX + 3 --------- 3 3 --------- 6 Green-White
4 no connection 4 --------- 4 Blue
5 no connection 5 --------- 5 Blue-White
6 RX - 6 --------- 6 Green
7 no connection 7 --------- 7 Brown-White
8 no connection 8 --------- 8 Brown
FIG. 8 RJ45 wiring diagram