Room Switcher Detailed Configuration Options
29
N7142 User Manual
Change Password Section
To change the N7142 Room Switcher interface password, enter the current password in the field labeled
Old Password
, and enter a
new password in the
New
Password
and
Confirm
Password
fields. Click
Change PW
to accept the new password.
FIG. 25
Change Password
NOTE:
This password needs to match N-Able's stored password to allow auto-login using N-Able.
LDAP Section
The section of the
Settings
page shown in
is displayed when you click the
Configure
LDAP
link. Options are described in
.
FIG. 26
LDAP Section
Serial Source IP
Shows the IP address of the currently connected device
or displays
Disconnected
if no connection exists.
Only a single external connection can be accepted on
the port. If a device is currently showing the port
occupied (by a control system or other device), then
other connections will be rejected. However,
connection attempts from the same IP will override
the current connection.
Flush buttons
Disconnects all clients from the network port.
TABLE 12
Settings Page: Status Section (Cont.)
Option
Description
Notes
TABLE 13
Settings Page: LDAP Section
Option
Description
Enable LDAP
Enable to configure the unit to access the network’s LDAP (lightweight directory access protocol) services.
Server Domain
Enter the IP address of the LDAP server.
AD Name
Enter the Active Directory’s name.
Save LDAP
Click to save settings made to this section.
