AMX Modero X Series, Operation/Reference Manual, Page: 27 / 44

Installation
19 MXD/T-1000 10.1" Modero® X Series Touch Panels
13.
Reconnect the terminal Ethernet and USB to their respective locations on either the Ethernet port or
NetLinx Master.
Uninstalling the MXD-1000
The MXD-1000 is held in place to the back box via latch hooks and clips on the back box (FIG. 19), securing
it to the mounting surface. In certain circumstances, such as firmware updates or other maintenance that
requires accessing the device’s USB or Micro-USB ports, the device may need to be removed from the back
box. The clips that lock down the MXD-1000’s bottom edge (Landscape) or right edge (Portrait) may be
unlatched in order to remove the device from the mounting surface.
To remove an MXD-1000 from its back box:
1.
The bottom (Landscape) or right side (Portrait) of the MXD-1000 has a series of ventilation holes along
the molding (FIG. 20). From each end, count to the eighth and ninth holes on the row closest to the panel.
FIG. 19 Installing the MXD-1000
Latch Hooks
MXD-1000
Landscape)
Back Box
Mounting Surface
Snaps
If you see a gap between the panel and the back box, or feel any binding while
locking down the panel, stop immediately and verify that no cables or other items are
in the way. Do not force the panel into position, as this can cause damage to the
touch screen or the panel electronics.
FIG. 20 Underside of MXD-1000
Molding