Installation Guide
HPX-U100-BTN
Hydraport Single Button Module
Overview
The HPX-U100-BTN Hydraport Single Button Module (FG554-01) is designed to be
used in conjunction with the HPX-1600 Hydraport Base Assembly. See specifications
for module requirements. For more information on the HPX-1600, refer to
www.amx.com.
The HPX-U100-BTN provides a configurable momentary button and LED backlight on
the face of the Hydraport system.
Product Specifications
Installation
Attention!
Only a professional, AMX-qualified installer should
perform this installation. Installation must conform to all local codes.
This product may not be installed by the end-user.
Tools Required
•
Wire cutting pliers
•
Wire strippers
•
Small flat blade screw driver
•
Phillips Screw Driver (to access Hydraport Base Assembly)
CAUTION!
Ensure that the AC Power cord is disconnected from IEC
C-14 power inlet connector on the Hydraport Base Assembly prior to
disassembly of the Hydraport Base assembly or installation of the
HPX-U100-BTN Module (see FIG. 2).
Step 1 - Backside Termination
Before installing the module into the Hydraport Base Assembly, the backside
terminations of the module must be completed. This backside termination requires
connecting 4 insulated wires, or equivalent, to the 4 position phoenix terminal block
located on the back of the module.
Note that for terminations for which the far end of the cable is not accessible either
because the cable has been run under carpet, in a conduit or structure, or is otherwise
fixed, the cable must be placed through the retaining ring (note the orientation of the
retaining ring) then through the mounting surface from bottom to top, then to the
module -
before the module is placed into the base assembly
(FIG. 3).
Step 2 - Provide a Service Loop
Ensure there is sufficient cable length to provide a service loop for the cable after the
module is installed into the Hydraport Base Assembly (FIG. 4).
Note that the Hydraport Base Assembly travels up and down approximately 228.6 mm
(9”) during operation.
The service loop must accommodate this motion and provide for securing the cable to
the Hydraport Base Assembly for strain relief.
For more detailed information, please refer to the HPX-1600-XX Hydraport Base
Assembly Instruction Manual.
FIG. 1
HPX-U100-BTN Single Button Module
HPX-U100-BTN Specifications
Dimensions (HWD)
25mm x 52mm x 25mm (0.98” x 2.05” x 0.98”)
Weight:
0.1 Kg (3.53oz)
Enclosure:
Matt black finished face plate (Polycarbonate plastic).
Front Connections:
RCA style connections for:
• Composite Video
• Left Audio
• Right Audio
Rear Connections:
4 Position Phoenix terminal block with connections for:
• S1 Switch Connection 1
• S2 Switch Connection 2
• LED Anode
• LED Cathode
Compatibility:
• HPX-1600 Hydraport Base Assembly
Included Accessories:
Installation Guide
FIG. 2
HPX-1600 - Power Inlet Cord Removed
AC Power Cord
Power Inlet Connector
on HPX-1600
FIG. 3
Fixed Cable Passing Through Ring, Table and Into the HPX-1600 Chassis
FIG. 4
Secured Service Loop
Module
Fixed cables pass-through
Retaining Ring, Surface
to Module
Fixed cables pass-through
Retaining Ring, Surface
to Module
Retaining Ring
Mounting Surface
HPX-1600 Chassis
