For full warranty information, refer to www.amx.com
01/08
©2008 AMX. All rights reserved. AMX and the AMX logo are registered trademarks of AMX.
AMX reserves the right to alter specifications without notice at any time.
3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com
93-1052-03
REV: B
Front Panel DIP Switches
Each DIP switch pair controls the output gain and peak of the same-numbered
output signal. The default setting is both switches “Off” (down position; FIG. 5), which
represents unity gain and no peaking. The gain and peak adjustments can
compensate for long cable runs. To increase brightness of a destination’s video, set
the gain DIP switch to “On”. To sharpen a destination’s video, set the peak
DIP switch to “On”.
To adjust DIP switches:
1.
Using a small screwdriver or paper clip, flip the toggles on the DIP switches up.
See table below for values.
Flip either or both switches “ON” depending on the length of the cable run.
Optional – Breakout Cables
Breakout cables are available in the options shown in FIG. 6. The BNC connectors
are color-coded for RGBHV signals. The color code letter (see chart below) is also
on the connector housing.
Note
:
The connector examples above are not to scale for cable lengths, which vary.
For more information on breakout cable options, contact your AMX representative.
FIG. 5
Adjust DIP switches for gain and peaking
DIP Switch Settings
OFF (default)
ON
Result
Gain
Unity gain
+0.85 dB
Brightens image
Peaking
No peaking
8 dB @ 150 MHz
8 dB @ 300 MHz
Sharpens image
Example:
Outputs 2 and 3 are set to ON for gain & peaking
Outputs 1 and 4 are set to OFF / unity
FIG. 6
Optional break-out cables
BNC Color Code
R
Red
G
Green
B
Blue
H
Gray
V
Black
V
H
B
G
R
V
H
B
G
R
HD15 Male to BNC Female
HD15 Male to BNC Male
HD15 Male to HD15 Male Cable
FG1090-689 6 ft. (1.8 m)
Breakout Cable
FG1090-511 3 ft. (0.91 m)
Breakout Cable
FG1090-406 6 ft. (1.8 m)