AMX FG1010-06 Quick Start Manual Download Page 2

Page: 2 / 2

For full warranty information, refer to www.amx.com.

7/07

AMX reserves the right to alter specifications without notice at any time.

3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com

93-900-846

REV: A2

AF-10

Note: The AF-10 supports up to six DVI-D to RGBHV converter boards.

To attach connectors:

Insert the DVI-D and HD-15 cable connectors into the receptacles on the
AF-10 board (FIG. 5).

Plug the power cord into the power receptacle on the rear of the AF-10 and into
the power source.

DVI-I Connector Pinout (DVI-D Signal)

HD-15 Connector Pinout

Note: 55 mA supplied on output pin 9; power draw not to exceed 50 mA per port.

FIG. 5

Attach DVI-D & HD-15 cable connectors

FIG. 6

DVI-I connector pinout for converter module or board

FIG. 7

HD-15 connector output pinout for converter module or board

From source PC

To destination monitor

DVI-I receptacle

HD-15 receptacle

DVI-D connector

HD-15 connector

Summary of Contents for FG1010-06

Page 1: ...in Hertz see table above If the frequency setting is not located under the Monitor tab try selecting other available tabs 9 Click Apply and then click OK on each dialog box to exit 10 Power down the...

Page 2: ...o attach connectors 1 Insert the DVI D and HD 15 cable connectors into the receptacles on the AF 10 board FIG 5 2 Plug the power cord into the power receptacle on the rear of the AF 10 and into the po...