Installation Sheet
RDM-3EM and RDM-6EM
Energy Management Modules
The RDM-3EM (
FG606-81
) and RDM-6EM (
FG606-80
) are 3 and 6
channel switching energy management modules. They are designed for use
with the RDA series of enclosures in an AMX Lighting™ system.
For more detailed installation and operating instructions, refer to the
Radia
Lighting Control System
Instruction Manual, available on-line at
www.amx.com
.
The RDM-3EM and RDM-6EM are designed with the most advanced
latching energy management relays to support heavy duty commercial
applications, building automation, and loadside management. Equipped
with on-board module microprocessors, both support relay control and
sequencing. Features include:
•
User selectable delays in sequencing mode to minimize inrush current
and stress on the electrical distribution system.
•
Selectable strapping facilitates multiple relays on one Radia control
channel for large area control.
•
Manual on/off override on each relay independent of control system.
•
Relays retain their state during power and control system outages.
•
Visual Status Indicators on each relay.
•
Latching relays do not consume any control current, except when they
change state, eliminating the need for additional Radia power supplies.
Specifications
•
Dimensions (HW): 10.00" x 2.75" (25.40 cm x 6.99 cm)
•
Non-phase dependant
•
Use wires rated at 75°C (167°F)
•
Torque terminals to 4.4 in lbs.
•
Wire size: 26 AWG to 10 AWG
•
Wire stripping length: 0.28" (7 mm)
•
Weight: 15 oz. (RDM-3EM) and 1.5 lbs. (RDM-6EM)
Included Accessories
•
4 mounting screws
•
Control wiring harness
RDM-3EM and RDM-6EM UL and C-Ul Ratings
•
General purpose: 120, 240, 277, and 347
*
VAC, 20 A
•
UL/CUL916 Energy Management Systems.
•
UL/CUL508 Industrial Control Systems.
Suggested Switched Loads
•
Incandescent
•
Fluorescent
•
Transformer
•
Low voltage
•
General purpose
Caution: Pre-Installation Notes
•
All Class 1 wiring must be connected to proper terminals.
•
All control wiring must be connected to proper terminals.
•
Disconnect power while installing or connecting the unit.
•
Keep top and bottom air vents clear at all times.
•
Test loads for shorts before connecting.
•
Use low voltage wires with a 300 volt rating or greater.
•
Use field installed copper conductors.
•
All electrical ratings are for continuous duty.
•
For indoor use only.
FIG. 1
RDM-6EM
Mounting
points
Relays
Sequencing
Delay Jumpers
(JP1 and JP2)
Control
Port
Strapping
Jumpers
(JP3 - JP7)
(1-6)
1
2
3
4
5
6
Mounting points
FIG. 2
RDM-3EM
Mounting
points
Relays
Sequencing
Delay Jumpers
(JP1 and JP2)
Control
Port
Strapping
Jumpers
(JP3 - JP4)
(1-3)
1
2
3
Mounting points
*
Agency approval pending
