AMX Endeleo Multi-Format Receiver UDM-RX02, Operation/Reference Manual, Page: 44 / 108

UDM-0102 Configuration - Status Page
30 UDM-0102 and UDM-RX02 Operation/Reference Guide
Control Options
Administrators can issue IR commands directly from the UDM WebConsole, via the Control options on the
Status page.
Executing an IR Command
1.
Select the Input Device that will receive the command from the Input drop-down menu.
2.
Click the down arrow on the Control drop-down menu to access a listing of supported commands
(FIG. 31), and
select the desired command.
3.
Click the Execute button to send the selected command to the Input Device.

If a custom control is required, type in the IR code for the command. Refer to the Endeleo IR
Codes section on page 62 for information.

It is also possible to control centrally located hardware such as DVD players, via options on the
Devices page. Refer to the
Sending a Command to IR-Controlled Devices section on page 43.
Ensure the device’s IR commands have been learned by the Hub first. Refer to the
Creating and Learning an IR Protocol
section on page 59 for details.
Ensure that an IR01 IR Emitter Module is connected to the UDM-RX02’s IRTX port.
Attach it to the device’s IR sensor before issuing a command. This IR Emitter Module
is used to transmit the command from the UDM-RX02 to the device’s IR sensor
FIG. 31 Status Page - Control drop-down menu
Execute button
Supported commands
Execute
button