Initial Configuration
18
NetLinx Integrated Controllers (Firmware v4)- WebConsole & Programming Guide
c.
To finish the process, click
Reboot Device.
d.
Click
OK
to close the dialog.
6.
To specify a network IP address (FIG. 11):
a.
Select
Specify IP Address.
b.
Enter the IP parameters into the available fields,
c.
Click
SET IP Information
to retain the pre-reserved IP Address to the Master.
d.
To finish the process, click
Reboot Device.
e.
Click
OK
to close the dialog.
7.
Repeat steps 1 - 5 from the previous section, but rather than selecting the
Serial
option, choose
TCP/IP
and edit the settings
to match the IP Address you are using (Static or IP).
8.
Click on the
Authentication Required
radio box (
if the Master is secured
) and press the
User Name and Password
button to
enter a valid username and password being used by the secured Master.
9.
Click the
OK
to close all dialogs and return to the main application.
Using the ID Button to Change the Master Device Value
Use the ID Button on the rear panel of the Controller in conjunction with ID Mode function in NetLinx Studio to establish a NetLinx
Device ID for the device. The steps described and the dialogs shown in this section are in the
NetLinx Studio
application.
NetLinx Studio is available to download from www.amx.com.
Refer to the NetLinx Studio on-line help for information on using NetLinx Studio.
1.
Access the
Device Addressing
dialog (FIG. 12) by selecting
Diagnostics
>
Device Addressing
.
2.
Enter the system number in the
Destination System
field.
3.
Enter the desired device number in the
Change to Device
box (
Device
field), and again enter the system number (in the
System
field).
4.
Click the
Start Identify Mode
button. This action activates Identify Mode on the named System.
NOTE:
"Identify Mode" means that the system is put on hold while it waits for an event from any NetLinx device in the named
system (for example, pushing the ID button on a NetLinx device). The device that generates the first event is the device that gets
identified.
The Device Addressing dialog displays the "
Waiting...Press Cancel to Quit...
" message, indicating that Identify Mode is currently
active (NetLinx Studio is waiting to detect a device - FIG. 13).
FIG. 11
Network Addresses dialog (Specify IP Address)
FIG. 12
Device Addressing dialog
