Enova 21xx All-in-One Presentation Switchers
17
Enova DVX-315xHD & DVX-215xHD All-in-One Presentation Switchers - Instruction Manual
Enova 21xx All-in-One Presentation Switchers
DVX-2150HD/2155HD/2110HD
FIG. 3
Enova DVX-2150HD-SP
Specifications
The following table lists the specifications for the Enova 21xx All-in-One Presentation Switchers:
DVX-2150HD/2155HD/2110HD Specifications
Power:
100-240V, 47/63 Hz AC supply
Power Consumption:
• 80 Watts typical without amplifier
• 85 to 90 Watts typical average with amplifier
• 30 Watts typical in low-power mode
Memory:
• 256 MB SDRAM
• 1 MB Non-volatile RAM (NVRAM)
• 4 GB Flash
Amplifier:
• 2 x 25W into 8 Ohms Class D stereo amplifier (capable of driving loads in the range of 2-8 ohms)
(-SP models only)
• 70V or 100V at 75W amplified variable mono audio (-T models only)
Integrated Controller:
Equivalent of a NetLinx 2100 central controller on-board
Front Panel Components:
LEDs:
• LINK/ACT (green) - Link/Activity LED lights when the Ethernet cables are connected and
terminated correctly and blinks when receiving Ethernet data packets.
• STATUS (green) - Status LED blinks to indicate that the system is programmed and
communicating properly.
• INPUT (yellow) - Input LED blinks to indicate that the Controller is receiving data.
• OUTPUT (red) - Output LED blinks to indicate that the Controller is transmitting data.
• RS-232/422/485 (red/yellow) - 3 sets of LEDs indicate that RS-232/422/485 Ports (1-3) are
transmitting or receiving data.
• RELAYS (red) - 4 LEDs indicate relay channels 1-4 are active (closed) on Port 4.
• IR/SERIAL (red) - 4 LEDs indicate that IR/Serial channels 1-4 are transmitting control data on
Ports 5-8.
• I/O (yellow) - 4 LEDs indicate that I/O channels 1-4 are active on Port 9.
LCD display:
Liquid crystal display (2 lines with 20 characters per line) indicates current volume level and displays
the Video, Audio, and Status menus. See the
section on page 25 for details.
SWITCH pushbutton:
Press to access the Switch menu on the LCD display. Use the menu to choose to switch audio, video
or both from any input to any output.
TAKE pushbutton:
While in the Switch menu, press to implement an audio/video switch.
VIDEO MENU
pushbutton:
Press to access the Video menu on the LCD display. There are two video menus (VIDEO OUTPUT and
VIDEO INPUT) and both are accessible by using this button. Multiple presses cycle through the
various VIDEO menus.
AUDIO MENU
pushbutton:
Press to access the Audio menu on the LCD display. There are three audio menus (AUDIO OUTPUT,
AUDIO INPUT, and MIC) and all are accessible by using this button. Multiple presses cycle through
the various AUDIO menus.
Continued
