![background image](http://html.mh-extra.com/html/amx/autopatch-af-10/autopatch-af-10_quick-start-manual_2937417002.webp)
For full warranty information, refer to www.amx.com
8/07
©2007 AMX. All rights reserved. AMX and the AMX logo are registered trademarks of AMX.
AMX reserves the right to alter specifications without notice at any time.
3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com
93-40-810
REV: B
4.
Insert the screws (from Step 2) into the holes on the connector assembly and
tighten the screws until they are snug.
5.
Attach cables to the accessory board’s input/output connectors as shown in the
board’s documentation.
6.
Plug power cord into the power receptacle and into the power source.
To remove accessory boards:
1.
Unplug the card frame.
2.
Remove input/output cables from the board.
3.
Remove screws from the connector assembly.
4.
Push down on the board extractor handle.
5.
Carefully pull the board straight out and place in a static shield bag.
6.
If replacing the board, see Steps 3 and 4 on previous page.
If leaving the slot empty, place a board plate to cover the empty board slot and
insert two screws. Tighten the screws until they are snug.
7.
Plug power cord into the power receptacle and into the power source.
FIG. 5
Insert and tighten screws until snug
VIDEO 2
VIDEO 1
VIDEO 2
VIDEO 1