For full warranty information, refer to www.amx.com
7/07
©2007 AMX. All rights reserved. AMX and the AMX logo are registered trademarks of AMX.
AMX reserves the right to alter specifications without notice at any time.
3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com
93-40-819
REV: A1
To attach cables to a module:
1.
Fasten the locking S-Video plugs from the source and destination devices onto
the S-Video connectors (FIG. 4 previous page).
2.
Plug the power cord into the power jack on the module and the power source
(FIG. 5).
3.
Apply power to the source and destination devices.
To attach cables to an AF-10:
1.
Fasten the locking S-Video plugs from the source and destination devices onto
the S-Video connectors (FIG. 4 previous page).
2.
Plug the power cord into the power jack on the rear of the AF-10 and the power
source.
3.
Turn on power source.
The Power Indicator on the front of the AF-10 illuminates.
S-Video Board Placement
Note: For instructions on installing additional boards, see the AF-10
Quick Start Guide.
•
1:4 boards only – may be placed in AF-10 in any available slot
•
1:4 and 5-out boards – place in AF-10 in alternating board slots
according to the pattern below
To place S-Video 1:4 & 5-out boards in an AF-10:
Install the 1:4 board in an even numbered board slot (counting from left to right).
Install the 5-out board in the adjoining slot to the left of the 1:4 board. The input on
the 1:4 board will then route signals to its own four outputs plus the five outputs on
the 5-out board for a total of nine outputs.
FIG. 5
Attach power cord and S-Video connectors
FIG. 6
Attach S-Video cables onto connectors
FIG. 7
Install 1:4 boards & 5-out boards in adjoining slot pairs
Power
From source
To destinations
From source
To destinations
1:4 boards in even-numbered slots
5-out boards to the left of 1:4 boards in odd-numbered slots
