Usage Notes
1. Do not power on the amplifier until all input sources and speakers are securely
connected. Turn the volume knob to its minimum setting before powering on the
amplifier to prevent speaker damage.
2. The total power consumption rating of the speakers must not exceed the amplifier’s
continuous power rating. The 8 ohm connector should not be used for 70V or 100V
speakers. When using this connection, the total speaker impedance should be 8 ohms.
3. If the amplifier detects a surge or irregular signal input (including power surges,
excess signal or other interference), a short-circuit condition in the speaker wiring or an
excessive speaker load, the amplifier will shut down for self-protection. If this occurs,
please turn the amplifier off, check for these problems and take corrective action before
turning the amplifier on again.
